|
1)Adjust the pressure of
heat-press board. Try the pressure first--put printing stock
on the base board, press the handle. It will affect the
quality of finished product if it's too tight or too loose.
Adjust the pressure by the button until suitable.
2)Lift the upper board and get
printing stock out.
3)Turn on power.
4)Set the temperature and time
according to different materials.
5)When it reaches desired
temperature, place the printing stock on the board and the
transfer paper on a proper place. Then put Teflon paper on
the top.
6)Press the handle down and
the timer will start to count. Upon hearing music, open the
machine.
7)Get printing stock out and a
complete image will be on the printing stock.
Tips:(1)
In the process
of preheating, don¡¯t put the handle down unless the
temperature has reaches the setting degree.
(2)
There¡¯re two
ways to remove base paper¡ª¡°Hot-split¡± and ¡°cool-peel¡±.
Master the right time and temperature due to different
materials.
(3)
The machine
shows temperature in international standard of centigrade.
To avoid troubles, please be aware that different districts
uses different standard. Below is unit conversion chart
between centigrade and Fahrenheit. There is one such chart
on the machine.
¡¡
F=1.8C+32
220C=428F 200C=392F 190C=374F
180C=356F 160C=320F 140C=284F
http://asc365.com |
